
P60/Combox60 upgrade instructions			2024-08-27 


1 Turn on your Sentrac with the probe to upgrade connected, and wait until the operation screen is shown. (Alternatively press 3 times in the O of INFICON)

2 Copy the files (p60.inf + p60_vx_xx_xx.hex) to the USB-C memory stick.
  If these files already has been copied to the Sentrac, Sentrac will, after warmup, check if the probe connected has an older s/w version and
  ask if it shall be upgraded. Then skip this step end go directly to step 5.   

3 Attach the USB memory stick to Sentrac. 
  A pop-up screen is shown indicating that an probe upgrade was found on the USB. (If the version is already exist on Sentrac, no pop-up screen will appear)

4 Press the accept button to start the upgrade process.
  The upgrade files are now copied to internal memory in Sentrac. This will take 10-12 seconds.  

5 A pop-up screen will then appear asking you to start the probe upgrade. Press accept.
  The transfer/upgrade process is shown on the Sentrac screen.

7 The installation is ready when Sentrac warmup screen shows and the probe info will appear with the new version. 
  Sometimes the Sentrac has to be restarted.

8 Don't forget to remove the USB memory stick

